CEL-Fix Adaptors Euro 5/6 M18 with Metallic Catalytic Converter 0-90 degrees

This Oxygen Sensor CEL-Fix adaptor is a solution for vehicles with titanium oxide sensors or "smart" Engine Control Units (ECUs) with sophisticated checks where an electronic oxygen sensor simulator cannot achieve the desired results. It is universal and applies to almost all EOBD vehicles which have two oxygen sensors (one before and one after the catalytic converter). This CEL-Fix is used to restore a normal signal for the oxygen sensor when the catalyst is removed or replaced with a racing catalyst resulting in an error message (CEL-Check Engine Light) in the controller. Unlike simple designs that place the Oxygen Sensor just a bit away from the exhaust gas stream and prevent the CEL only for short term, our CEL-Fix adaptor has an integrated HJS mini-catalyst which actually improves the exhaust gas quality before it is measured by the Oxygen Sensor. It comes with an Oxygen Sensor Standard Thread M18x1.55 on each side for easy installation. The CEL-Fix adaptor MUST be installed ONLY on the second Oxygen Sensor which is always located after the Catalytic converter. For vehicles with 2 parallel catalytic converters (Left and Right), must be used 2 CEL-Fix adaptors, always to the second Oxygen Sensor after the Catalytic Converters. Warning: Never install the CEL-Fix adaptor to the first oxygen sensor (nearest to the engine) located in front of the catalytic converter, since it is responsible for proper information of the mixture because the CEL-Fix adaptor it will not work! Attention: After the installation of the adaptor you must take your car to a mechanic to switch off the CEL by computer!